Water Heater Service and Repair

Call us today if you need service or repair on your heating, cooling, water heating or fireplace systems! CM Heating Comfort Masters is your local answer to staying comfortable all year long.

C.M. Heatingstarstarstarstarstar5.0 / 5

1146 Total Reviews C.M. Heating425-259-0550$1415 Broadway, Everett WA



Water Heater Service and Repair Everett, Washington

C.M. Heating services and repairs all types of water heaters in Everett, WA. We specialize in tank and tankless hot water heaters. Our service technicians can diagnosis and repair your electric or gas water heaters promptly. We offer same day water heater service in Everett, WA.

Let us help you decide how best to solve your water heating problems. If repair is the best choice, C.M. Heating stocks the parts you need. If you need a new water heater in Everett, WA, we install a range of water heating systems.


CM Heating performed a water tank maintenance. Tune and clean gas furnace. Cleaned burners and flame sensor. Tested the gas pressure and igniter. Took amp draws of the blower motor and inducer motor. Visually inspected the control board and blower assembly. Checked filter. Furnace is running properly at this time. Recommend upgrading the air filter system to air Scrubber

Everett, WA
04-09-2019


CM Heating performed a water tank diagnostic and Recommend replacing the expansion tank. The customer would like to move forward with the repair.

Everett, WA
06-05-2019


CM Heating Performed a diagnostic on hot water tank. The unit has some rust within the tank and bimetal is signal is weak. Recommend replacement tank.

Everett, WA
08-12-2019


CM Heating did a return visit and found Water line to hwt was shut off. Turned back on.

Everett, WA
08-08-2019


CM Heating completed Maintenance on furnace and water heater. Tech found no issues to note with either piece of equipment. Both units running as designed.

Everett, WA
08-14-2019


CM Heating performed a hot water tank diagnostic and Re lit pilot light on water heater. Pilot was put out due to flood. Water heater is 18 years old and is interested in tankless. Customer will call for consultation when she finds out work schedule. Thermocouple is in bad shape. Tech does not think tank will last much longer.

Everett, WA
09-13-2019


CM Heating Removed water from internals and checked for additional water damage. Dried, and purged lines. Tank is now working as normal.

Everett, WA
09-12-2019


CM Heating Completed hot water tank and furnace maintenance. Hot water tank is fairly new and functioning properly. Furnace is in good working condition however due to its age I would recommend replacement of entire unit instead of replacing any major components that may fail in the future.

Everett, WA
07-08-2019


CM Heating performed Maintenance on Hot Water Tank and furnace. Removed and cleaned the burners and flame sensor. Tested the Igniter, carbon monoxide levels, and delta t. There is metal flashing obstructing the capacitor. Unable to test. Took amp draws of motors. Visually inspected the control board and blower assembly. Blower assembly has significant dust accumulation after the filter. There is a hole cut into the installation and duct work allowing dust/dirt past the filter. The control board has burn marks on the back. Hot surface Igniter is turning white with age. ***no guarantee on functionality of equipment without repairs or replacement. Recommend replacing the equipment due to age and accumulating cost of repairs.

Everett, WA
06-07-2019


CM Heating performed a Maintenance on gas furnace and water heater, pulled and cleaned burners and flame sensor, replaced igniter, tested motors and capacitor, tested gas pressure, drained and inspected water heater, system is running at this time, recommend pulling blower motor and cleaning along with adding an air scrubber plus to protect system better

Everett, WA
06-07-2019


CM Heating Performed a gas furnace and hot water tank maintenance service. Conduct a inspection of water and gas lines for leaks. Check the condition of burners- The furnace burner has some rust build up. Ensured safety devices are working as design within the furnace. Consumable components are within specifications per manufacture. Flush sediments from hot water tank. All operations normal at this time.

Everett, WA
07-12-2019