Furnace Service and Repair

C.M. Heatingstarstarstarstarstar5.0 / 5

1345 Total Reviews C.M. Heating425-259-0550$1415 Broadway, Everett WA

Furnace Repair in Lynnwood, Washington

Is your heating system not working, or perhaps behaving a little differently? Have you noticed that your home in Lynnwood, WA is not maintaining temperature properly and making funny noises?

If your gas furnace is not working call C.M. Heating now. We fix broken heating equipment all the time in Lynnwood, WA. Or if your system is just getting old, or giving you reasons not to trust it any more let us know. We have many years of experience and we can help you make the right choices when it comes to your furnace system.


CM Heating went out for a furnace diagnostic and Sold replacement equipment being installed on 12/31 7-9 arrival

Lynnwood, WA
01-02-2020


CM Heating went out for a diagnostic on a gas furnace and Diagnosed failed igniter. Replaced igniter and system is now running.

Lynnwood, WA
12-24-2019


CM Heating Performed a diagnostic service on gas furnace. Found a gas leak, advised customer to avoid usage and/or shut off gas to fireplace. This unit has components that are discontinued.-No repair option available. CM Heating currently not installing zero clearance fireplaces at this time.

Lynnwood, WA
12-20-2019


CM Heating went out for a furnace maintenance and found System was short cycling upon arrival. Performed maintenance on gas furnace. Wiped down unit. Checked all major components. Couldn’t recreate the problem after the maintenance. Cleaned blower assembly. Added surge protection. System is working properly at this time.

Lynnwood, WA
01-15-2020


CM Heating performed a Diagnostic on furnace. Retrieved fault code 24 open fuse. Replaced the fuse and system started working normally. The basement has an excess of water we cannot find the source. The pvc fittings are all glued and the condensation pump is working. There is no water inside the furnace. There is a possibility the water is leaking from the foundation. Checked burners and flame sensor. Tested igniter. Took amp draws of motors. Visually inspected the control board and blower assembly. Checked filter. Furnace is running properly at this time

Lynnwood, WA
01-14-2020