Heat Pump Service

C.M. Heatingstarstarstarstarstar5.0 / 5

1257 Total Reviews C.M. Heating425-259-0550$1415 Broadway, Everett WA

Heat Pump Service Marysville, Washington

C.M. Heating services all types air conditioners or heat pumps in Marysville, WA. Our service technicians can diagnosis and repair your packaged or split systems in Marysville, WA and get your HVAC system back up to speed promptly.

Let us help you decide how best to solve you comfort and efficiency challenges quickly. If repair is the best choice, C.M. Heating stocks the parts you need. If you need to update your AC or Heat Pump system in Marysville, WA, we install a range of replacement systems.


CM Heating Performed maintenance on ductless heat pump. Checked and/or clean air filters and cabinet housing as needed. Checked for loose electrical connections, and refrigerant leaks. Help customer setup thermostats. All units are working properly.

Marysville, WA
09-12-2019


CM Heating performed Maintenance on heat pump. Checked delta t, capacitor, board and took amp draws of the compressor. Outdoor temp is 61 degrees and will not give accurate delta t or cooling pressures. Heat pump is running at this time Recommend adding surge protection to the heat pump to better protect the unit As well as Tuned and cleaned gas furnace. Checked burners and flame sensor. Tested capacitor and gas pressure. Took amp draws of motors. Visually inspected the control board and blower assembly. Checked filter and delta t. Furnace is running properly at this time

Marysville, WA
09-09-2019


CM Heating performed service on ductless system and water heater. Ductless system is in good working order. Tech found lots of sediment and debris in water heater. Tech flushed around 7-8 gallons of water and dark water filled with sediment was found in each bucket. Highly recommended that customer think about new unit. System is from 2002.

Marysville, WA
09-09-2019

American Standard HVAC 4A6V8036A1000BA
Marysville, WA
10-03-2019

4A6V8036A1000BA
CM Heating went out for a heat pump diagnostic and Upon my arrival the unit was working. Conducted a maintenance service on the air handler and heat pump. -Took measurements of consumable components and verify they are within specific tolerance. -Compared baseline refrigerant data to current readings. -Inspect electrical and mechanical components for premature wear/failure. -Inspect overall operations. -Filter is still ok, at about 50% The unit is working as normal at this time. Notes: Refrigerant is a little out of manufacturer design range, indicate the unit may be slightly over charge or contaminated. The current temperature during this testing is 48 degrees. Not the most optimized temperature to get precise readings.

Marysville, WA
11-07-2019

4A6V8036A1000BA
CM Heating performed a heat pump diagnostic and found Outdoor condenser fan motor is bad. Motor winding's are shot. Motor is shaking extremely bad. Start kit is bad as well. Capacitor has no rating. Parts have been ordered.

Marysville, WA
11-12-2019

4A6V8036A1000BA
CM Heating went out for a heat pump diagnostic and found The heat pump unit is currently working correctly at this time. Made some adjustments on the thermostat and will need to return to investigate inadequate air flow to half the house.

Marysville, WA
10-29-2019

4A6V8036A1000BA
CM Heating Performed a heating and cooling maintenance service on the gas furnace-heat pump unit. -Took measurements of consumable components and verify they are within specific tolerance. -Compared baseline refrigerant data to current readings. -Inspect electrical and mechanical components for premature wear/failure. -Inspect overall operations. -Cleaned air filter. All comfort equipment are operating well within design perimeters at this time.

Marysville, WA
11-14-2019