Furnace Cleaning

C.M. Heatingstarstarstarstarstar5.0 / 5

1257 Total Reviews C.M. Heating425-259-0550$1415 Broadway, Everett WA

Furnace Cleaning Stanwood, Washington

Keeping your heating system in Stanwood, WA in good working order working requires scheduled maintenance. All equipment manufacturers suggest at least annual system cleaning and preventative maintenance. Our heating service technicians have years of experience working on furnaces like yours in Stanwood, WA. C.M. Heating service vehicles are on call and are fully equipped with the tools and parts necessary to keep your hot air furnace in good working order.

Our furnace repair, furnace service or replacement pricing is competitive. Our estimates are always firm with no hidden surprises. You can rely on C.M. Heating to advise you properly and to do excellent work promptly.


CM Heating performed Maintenance on gas furnace and fireplace, cleaned burners and flame sensor, and pilot assembly, pulled and blower motor assembly, replaced filter, tested capacitor and igniter, inspected electrical components and control board, both systems are running normal at this time

Stanwood, WA
07-29-2019


CM Heating **Customer reported the system is not properly heating the home. Tune and clean gas furnace. Checked burners and flame sensor. Tested capacitor and igniter. Took amp draws of motors. Visually inspected the blower assembly. Checked filter and delta t. ***The pressure switch is periodically opening in the middle of the cycle and does not start unless the vent hose is disconnected. This particular pressure switch is no longer made and will need an updated part. I cannot guarantee the equipment will work properly with a super ceded part ***Will not remove sword burners to clean. They tend to be rusted and break easily. Sword burners are no longer made and very difficult to replace. Recommend replacing equipment due to age and repairs needed. The furnace has exceeded life expectations. ***CUSTOMER DECLINED REPAIRS. NO GUARANTEE ON FUNCTIONALITY OF EQUIPMENT WITHOUT REPAIRS. If equipment is not functioning properly will need to charge diagnostic $99

Stanwood, WA
08-07-2019